WIRE ROD BREAKDOWN LINES

High performance, longer lifespan, easy maintenance and low wear and tear! Our rod breakdown lines for copper, aluminum and aluminum alloy are the safest bet to realize the first step of your production. Wire dies with pressure chamber. Transmission can be done via belts (for an easier maintenance) or each capstan can be motorized (for maximum performance), this latter solution allows drawing not only one wire, but even two wires at the same time.

-ROD BREAKDOWN MACHINES

Models: T40 - T50 - T50/2
Speed up to 38 m/sec.
Wire cross section reduction can be programmed (in case of multi-motor machine)
Wire elongation can also be programmed (in case of multi-motor machine)
Number of dies: from 4 up to 15 Inlet wire rod diameter: from 8 up to 10 mm (Cu) – from 9,5 up to 12,5 mm (Al & alloys) – or more upon customer’s special requirement.
Outlet wire diameter: from1 up to 5 mm
Pulling capstans diameter: T50: (500 – 350 mm) or T40 (400 – 300 mm)

-ROD BREAKDOWN MACHINES FOR TROLLEY WIRE

These machines are tailor made upon customer’s requirements for inlet wire rod diameters up to 28 mm and standard outlet cross section of 85-100-120-150mm²

-CONTINUOUS ANNEALERS

Models: F35 – F40 – F45 – F50
Zero speed continuous annealers for our various rod breakdown machine models.
They can be driven either via belts from the drawing machine or with independent motor.
Complete with their transformers whose power will be adapted to the maximum outlet wire diameter required by the customer and equipped with their steam generator or with nitrogen upon request, etc.

-DANCING ACCUMULATORS FOR ROD BREAKDOWN LINES

Models: PAT30 – PAT40 – PAT50/2
Vertical dancers for speed control between the various elements of the drawing lines.

-VERTICAL STATIC COILERS

Models: MC75 – MC100
Static coilers with capstans diameters 750 or 1000 mm, rosette layering, basket automatic
change, 3 positions, roll conveyor at floor level or underground.